PEAK-System Forum

Hello,

Thank you for the suggestion.

I am using Labview.

I have tryed to attach directly the Labview vi, but the extension .vi is not allowed. Because of this I posted in pdf.

Hello,

I am using the PCAN-Basic library from PCAN system: I have taken the RCV example and I have modified it to my purposes.
I have simply added a part after the CAN read while loop.

Hello,
Sorry for the delay I am replying but I was out of office.

Thanks for the suggestions: I will check the different points you have highlighted. In the meantime I will attach the pdf of my interface.

The goal of my application is to manitor, as I wrote in my first thread, 2 sensors in ...

Hello,
I have modified the RCV data in the Example of PCanBasic, but I am having some issues in recording signals.
The goal of my application is monitoring two sensors in parallel and for each the sensor I monitor two signals.

First of all I discriminate TX and RX signal coming from CAN. After the ...

Thank you so much.

I have followed your instructions and I have restarted Windows.

Good morning,

I have already installed the Labview drivers for PCAN-Basic on my portable (OS Windows7, 64bit, Labview2014).
I have modified the CAN RCV file to make it working with my application and it turns and works as I desire.

I tryed to make it working on the PC in my laboratory (OS Windows ...

Hi,

Thank you for you quick reply. I have followed your suggestion and now it works again.

Regards,
M

Hello,

I am using a PCAN USB opto-decoupled and I have installed with success all the related drivers.
It's more than two monthsI am using the PCANView without any problems.
Since yesterday I can't visualize in the correct way the Sending/Transmission interface of PCANView.

Every time I try to ...