PEAK-System Forum

In attachment

It looks like that module is working in normal operation mode (pcan_pcan.png)

Also tried to reload configuration with changed can speed for one channel to check if I am reloading confiugration correctly. CAN speed was changed but I am still in normal operation mode and not listen operation mode

Problem: CAN 1 Mode = CAN 2 Mode = CAN 3 Mode = CAN 4 Mode = 3 in configuration file but PCAN-Router Pro acknowledges CAN messages.

- send us the used configuration - in attachment (already sent in third post)
- send us a readable shematic of your setup - in attachment
- send us a step by step info ...

Hello,
Well, it does not. ('vector_pcan.png').

It looks like we do not understand each other. Therefore I created short video with capture session and saved it into attachment with extracted trace file.

Did you read my post? That is what I am complaining about. PCAN-Router Pro is configured to be in listen mode but no third device to acknowledge CAN messages is needed.

Yes, I set it to value 3. Configuration is in attachment.
I verified my test environtment (Vector CANcaseXL) how does it behave when CAN message is not acknowledged (attachment 'vector_vector.png')
Then I perfomed same test between CANcaseXL and PCAN-Router Pro and PCAN-Router Pro acknowledged CAN ...

Hello
I'm looking for information if transceiver HSGE2 supports listen mode.

Chapter 'Using an Alternative CAN Transceiver Module' lists possible transceivers as: CAN-HS, HSGE2, CAN-HS-1041, CAN-LS, CAN-LS-SW

However
'Appendix D - CAN x Mode' lists transceivers as: AU5790, AU7590, PCA82C251 ...

Is CAN record capacity doubled when using 4 GB CF card compared to 2 GB CF card? Or does this solution only make it possible to use larger cards in the device?

Could you clarify if my use case is not possible to do:

- I want to station PCAN-Router Pro on a machine
- Machine lives for multiple months with multiple power resets
- Some minor failure happens on machine that need to be analysed but machine continues to operate
- I want logs from couple of ...

Hello
I have problems when using circular logging of CAN traffic on CompactFlash card.

Measurement setup:
CAN 1 load: 1 msg/ms
CAN 2 load: 1 msg/ms
CAN 3 load: 0 msg/ms
CAN 4 load: 0 msg/ms

______________start_____end______last timestamp in record [s]
Generated _____13:54____06:48_____60783 ...