Hi,
I've solved the problem now. It was caused do to faulty wiring, but everything is working fine now. Thank you very much for your help.
Regards
Alejandro
Search found 3 matches
- Thu 22. Mar 2018, 18:21
- Forum: PCAN-PCI Express
- Topic: Error passive warning
- Replies: 8
- Views: 50164
- Fri 16. Mar 2018, 17:43
- Forum: PCAN-PCI Express
- Topic: Error passive warning
- Replies: 8
- Views: 50164
Re: Error passive warning
Hi,
thanks for the quick response. I have a couple questions. This model has an 8 MHz clock frequency, right? Right now, the bit timing parameters are: prescaler=1, tseg1=5, tseg2=2 and sync jump width=1. I believe these are the default parameters for a 1 Mbps transmission with a 75% sample point ...
thanks for the quick response. I have a couple questions. This model has an 8 MHz clock frequency, right? Right now, the bit timing parameters are: prescaler=1, tseg1=5, tseg2=2 and sync jump width=1. I believe these are the default parameters for a 1 Mbps transmission with a 75% sample point ...
- Thu 15. Mar 2018, 15:24
- Forum: PCAN-PCI Express
- Topic: Error passive warning
- Replies: 8
- Views: 50164
Error passive warning
Hello,
I'm using this interface for a project at my university. I have other devices on the bus and I can monitor their activity using PCAN-View if I set the PCAN-PCIe card to listen-only mode, but whenever I try to send something on the bus (not using listen-only mode, obviously) I get a status ...
I'm using this interface for a project at my university. I have other devices on the bus and I can monitor their activity using PCAN-View if I set the PCAN-PCIe card to listen-only mode, but whenever I try to send something on the bus (not using listen-only mode, obviously) I get a status ...