PEAK-System Forum

Hello Emil,

Thank you for letting us know!

BR

marvin

Hello,

What's the status of the LEDs?

Also, i'll be moving this to the correct forum

BR

Marvin

Hi, have a look at the corresponding can_user.c, this is the init-sequence for the channels. Use CAN_UnInitialize to bring a channel down again and bring it back up using CAN_Initialize ( hBus, &Timing_CANx[hBus]); Make sure to use your intended bitrate for reinitialization. This should enable your ...

Hello Allesandro,

These bitrate-constants are defined in can_user.h ("Inc" folder), if you want to use a different bitrate-config or define your own,
please modify/check this file.

BR

Marvin

Hello, Simply using defaults on a CAN-FD network will not be sufficent, you have to be particular about the config otherwise communication will not be established, CAN-FD is pretty strict and doesnt allow for much tolerance in bitrate settings. The defaults we include are also more defaults in our o...

Hello,

so we don't lose track, what's the current behavior you do see?

Can you outline which behavior specifically is reproducable (you have multile items under A, e.g)

Best Regards

Marvin

Hello,

PCAN-USB FD supports PCAN-UDS API, yes.

Timing issues are most likely of physical nature (bitrate config, termination)

please check.

BR

Marvin

Hello,

If i am not completely mistaken you are assigning DinStatus which you set to 0 to Din0,
then you would come up 0 every time regardless of what the input actually reads...

Am i misunderstanding what you are doing here?

BR

Marvin

Hello Alessandro, Issues as involved as this might be a better fit for an email request, i have to admit i lost track due to a high volume of support requests, i'm terribly sorry. Is this behavior replicable with both writing to EMMC as well as SD-Card? Also, just as a suspicion on my side: Can you ...

Hello, You were a bit faster than i expected with this! :D Can you send us the specification of what you need (maybe copy this thread and to it via email to info[at]peak-system.com? I will have to relay this to our development department, so we can check our resources and tell you more about pricing...