PEAK-System Forum

Hello Marvin,
Finally these custom settings worked with PCAN view. Yes, all other baud rates were working fine. We had an issue only with this 3.2Mbps baud rate.
Thanks for your support.

Hello Marvin,
First of all sorry that I put 3.4Mbps(instead of 3.2Mbps) in the problem statement I just realized my typo here.
We are struggling with 3.2mbps baud rate settings with PCAN.
Here are the settings of our device-

Nominal Bit Rate = 1Mbps
Data Bit rate = 3.2Mbps
CAN module clock source ...

Thanks for the tool.
However unfortunately i didn't have any success even after changing all the possible values provided by the tool.
Any help would be appreciated.

I'm not completely sure but the problem could be with the unavailability of 16 Mhz or 32Mhz crystal on the PCAN hardware.
I think with 24Mhz crystal we might not be able to create proper timing values for the exact 3.2MBPS data rate. There would be some deviation from PCAN side.
Please confirm if my ...

Hello,
Please find attached the screenshot.
We have connected our board to PCAN hardware. So just two nodes.
There is an acknowledgment error from the PCAN side for the messages being sent by our device.
And as there is no ACK, CAN controller of our device increment transmit error count and ...

Hello,
Thanks for getting back to me.
Yes you are right - PCAN-USB Pro FD by "PCAN USB Pro".
We are using the same bit rate settings with other devices as well.
We have the correct termination of 120 ohm.
We are using PCAN View Software for our tests.<Imagage Attached>
And we are not in Listen only ...

Hello,
We are having PCAN devices for our testing and development.
Recently we switched to CANFD protocol for one of our products and PCAN USB pro seems to be not working in reception mode for certain baud rates.

Here are our CAN FD baud settings -
nominal bit rate 1MBPS data bit rate 3.4MBPS ...