Thank you its working now. I have a general question, what happens the CAN ID in the dbc file doesn't match with truck can ID.
For example, in truck when I did testing the following can frame is for speed.
Can ID Hex - 0CF00400 to decimal ---> 217056256 ---> PGN is 61444
Can ID in DBC file for ...
Search found 3 matches
- Thu 10. Nov 2022, 05:32
- Forum: PCAN-USB
- Topic: Interfacing J1939 with PCAN USB - Other Truck
- Replies: 3
- Views: 4153
- Tue 8. Nov 2022, 16:58
- Forum: PCAN-USB
- Topic: Interfacing J1939 with PCAN USB - Other Truck
- Replies: 3
- Views: 4153
Interfacing J1939 with PCAN USB - Other Truck
Hello,
I gave up on the other truck I was testing since it had J 1708. I found an another truck which has J 1939 communication protocol. I started checking the diagnostic port if its working or not. The results are shown below.
Debug Conditions:
Voltage between Can H and Ground is 2.7 Volts ...
I gave up on the other truck I was testing since it had J 1708. I found an another truck which has J 1939 communication protocol. I started checking the diagnostic port if its working or not. The results are shown below.
Debug Conditions:
Voltage between Can H and Ground is 2.7 Volts ...
- Fri 4. Nov 2022, 15:58
- Forum: PCAN-USB
- Topic: Interfacing J1939 with PCAN USB
- Replies: 1
- Views: 1969
Interfacing J1939 with PCAN USB
Hello All,
I need some of your thoughts on how to diagnose the issue.
I am trying to interface PCANUSB with J1939 port in Kenworth T 800 (2008 trucks). IT has nine pin deusche connector. This is the pin diagram reference https://www.peak-system.com/PCAN-Cable-J1939.377.0.html?&L=1.
This is the ...
I need some of your thoughts on how to diagnose the issue.
I am trying to interface PCANUSB with J1939 port in Kenworth T 800 (2008 trucks). IT has nine pin deusche connector. This is the pin diagram reference https://www.peak-system.com/PCAN-Cable-J1939.377.0.html?&L=1.
This is the ...