PEAK-System Forum

Problem was solved by "formenergy" itself -> error inside the application code
Thanks for the feedback.

Hi,

please send us your gateways config via email (info.peak@hms-networks.com) and refer to this topis.

Note: The config can be exported into an ini file via the PCAN-Ethernets WebGUI.

Please load the driver with "sudo modprobe pcan" or reboot your PC so that the driver will be loaded automatically.

Hello,

please send an email to "info.peak@hms-networks.com" and refer to this forum post.

Hello,

as a simple test please check if the same error also appears with the PCANBasic API version 4.x.

Dear Mahesh,

please send us an email with additional infos about the exact problem.
Use the following email address and referr to this topic in your email.

support.peak@hms-networks.com

Nice to hear that the problem is solved now, thanks for the feedback.

Please connect the PCAN-Router with a PCAN-USB interface, avoid any other CAN devices, set the PCAN-Router into the Bootloader mode and then start the PCAN-View, select the PCAN-USB as hardware, use a baudrate of 500k and send the following message:


router_detect.jpg


What happens? Do you ...

What´s the value of the CAN termination?

Hi,

please take care that the PCAN-Router is in the bootloader mode.
What´s the status from the CAN1 and CAN2 LEDS? Are they blinking orange?
Which CAN port do you use for the flash procedure? CAN1 or CAN2?