Setting up IP routes for PC via Sockets

CAN to LAN Gateway in DIN Rail Plastic Casing
Post Reply
austin
Posts: 1
Joined: Fri 13. Aug 2021, 00:14

Setting up IP routes for PC via Sockets

Post by austin » Fri 13. Aug 2021, 01:49

Hi,

I am having some issues setting up the correct routing to be able to access CAN data via a socket. I have the "handshake" disabled per the instructions in section 1.3 of [1]. What would be the correct IP address for STEP 4 of (Routing » Manage Routes » Edit Route)? It says to 'Enter the IP address of the device that should act as the receiver for this route.' Is this a separate IP address that must be routed? Any information about how to utilize the "Destination" connection would be appreciated.

Thanks!

[1] https://www.peak-system.com/produktcd/P ... on_eng.pdf
Attachments
poi_config.ini
(2.96 KiB) Downloaded 36 times

S.Michaelsen
Hardware Development
Hardware Development
Posts: 77
Joined: Fri 10. Sep 2010, 13:11

Re: Setting up IP routes for PC via Sockets

Post by S.Michaelsen » Fri 13. Aug 2021, 06:56

Hi Austin,
this is simply the IP address of the destination, e.g. the PC you have opened your socket / running your our application to receive the data.

BR,
Stephan

Post Reply