Firmware Update for PCAN-USB FD

Post by **PEAK-System** » Tue 18. Jan 2022, 15:40

PEAK-Flash Firmware Update Tool - 01/2022 B E T A

Requirements:

Windows 10 (minimum 19H2) 32 or 64 Bit

C++ Redistributable Package for Visual Studion (is part of the package)

Please note that this software contains firmware that has not yet been officially released.
For the already officially released firmware versions, please download the official PEAK-Flash application from our support page.
But all included Firmware Versions are well tested and will be released soon.

Please download the File - unzip and run the Tool in the Folder PEAK-Flash.
If the PEAK-Flash does not start - check if the needed C++ Redistributable Package is installed
(it is also part of the Package - Folder "C++_Redistributable")

** DOWNLOAD LINK PEAK-Flash BETA **

PEAK-Flash_BETA_v1.4.2.zip: (19.67 MiB) Downloaded 53 times

Please NEVER Disconnect the Device or power off your PC when a Firmware Update is in progress. This could end up in a bricked device !

Historie / Changes

PCAN-USB FD Firmware (BETA)

v3.4.3
- Bugfix: CAN-Core, Error generator restart
- Bugfix: Status frame when leaving reset-mode during BusOFF suppressed
- Option added: send ACK as transmitter
- Option added: generate time-stamp at start-of-frame
- Option added: ignore BRS frames as receiver