Digital input various results

[marek.belisko]

Hi,

I'm using MicroMod Mix3 to capture state of digital inputs. I use DIN0 - DIN2 as inputs and while set on all of then reference 4.8V when capture received data by using candump I see n that I get logical 1 but after some seconds it goes to logical 0 and then back to logical 1. as said I have stable input voltage 4.8V. Any ideas what can cause this issue? I have basic setup only (no changes in DIP switches though). Thanks.

[M.Heidemann]

Hello,

Can you send us your configuration-file (.mcf) to support[at]peak-system.com?

Please reference this post in your email.

It's hard to evaluate whats the issue without seeing the configuration.

Best Regards

Marvin

[marek.belisko]

Hi,

it looks like I need to provide input voltage higher then 4,7-4,8V otherwise detection is not reliable. Not I provide bit more and it works perfectly fine. Thanks.

BR,

marek

[PEAK-Support]

4.8V is the minimum Voltage for detecting the High Level. it is always better to add some milivolts on top for exact detecting the High Level.

Unbenannt.JPG (13.54 KiB) Viewed 7032 times