data transmission Canalyzer

Configurable System for Data Acquisition and Data Processing
Post Reply
MaThias.U
Posts: 4
Joined: Tue 12. Jun 2018, 15:08

data transmission Canalyzer

Post by MaThias.U » Tue 12. Jun 2018, 15:26

Hello,
I put the thermocouple into operation.
The Basic Configuration with Thermocouple Configuration has been made. Only the Can transfer rate was changed to 250kbit / s.
The values are displayed using the canalyzer.
The values are too high. Type K sensor is used. Where can I set the conversion or units?
Many Thanks

User avatar
S.Schott
Hardware Development
Hardware Development
Posts: 33
Joined: Mon 4. Oct 2010, 16:50

Re: data transmission Canalyzer

Post by S.Schott » Tue 12. Jun 2018, 15:57

Hello.

The MU-TC1 Thermocouple sends data in 1/16 degrees (see manual p.26).
So you may either set a scale of 16 in the device so it sends full degree.
Or you may apply a factor 16 in your visualization system.

A tutorial (in german) is found on the product DVD:
\Tools\Thermocouple Configuration\shipping config\Konfigurieren des MU-TC1.pdf
See exercises 1.x (starting p.8 onward).

MaThias.U
Posts: 4
Joined: Tue 12. Jun 2018, 15:08

Re: data transmission Canalyzer

Post by MaThias.U » Tue 12. Jun 2018, 16:08

Thank you!

Post Reply