Implementing Simple CanOpen App with Peak-Basic

The free CAN Software API (Application Programming Interface) for Windows®
Post Reply
blipton
Posts: 1
Joined: Sat 11. Jul 2020, 02:22

Implementing Simple CanOpen App with Peak-Basic

Post by blipton » Sat 11. Jul 2020, 02:30

I haven't found any affordable commercial software that allows one to read/plot data from a CanOpen sensor.

I'm not terribly familiar with CanOpen, so I'm not sure if this biting off more than I can chew.. especially, since I've never programmed using the Peak API.

Anyone have any thoughts how do-able implementing CanOpen sounds using Peak? Are there any recommended project examples that may make for a good starting/learning point?

User avatar
U.Wilhelm
Sales & Support
Sales & Support
Posts: 1130
Joined: Fri 10. Sep 2010, 19:34

Re: Implementing Simple CanOpen App with Peak-Basic

Post by U.Wilhelm » Sun 12. Jul 2020, 12:52

You should ask the CANopen tool developer if they support our CAN modules. We offer CAN API which could easily use with most CANopen tools/stacks. We also have an CANopen software list available here in the forum. Check third party application section.
--------------------------------
PEAK-System Technik
Technical Support Team
support@peak-system.com
-------------------------------

Post Reply