Page 1 of 1

Implementing Simple CanOpen App with Peak-Basic

Posted: Sat 11. Jul 2020, 02:30
by blipton
I haven't found any affordable commercial software that allows one to read/plot data from a CanOpen sensor.

I'm not terribly familiar with CanOpen, so I'm not sure if this biting off more than I can chew.. especially, since I've never programmed using the Peak API.

Anyone have any thoughts how do-able implementing CanOpen sounds using Peak? Are there any recommended project examples that may make for a good starting/learning point?

Re: Implementing Simple CanOpen App with Peak-Basic

Posted: Sun 12. Jul 2020, 12:52
by U.Wilhelm
You should ask the CANopen tool developer if they support our CAN modules. We offer CAN API which could easily use with most CANopen tools/stacks. We also have an CANopen software list available here in the forum. Check third party application section.