PCAN-View acceptance filter not working

[Quintest]

I tried to use the acceptance filter for 29-bit identifiers in PCAN-View V5.0.3.852.
I tried it with 0x1C440013 as start and 0x1C460013 as end.
A minor issue was that PCAN-View doesn't store these values even when I set "Store Filter Settings".
The main issue was that the trace window doesn't show any messages at all when a measurement is done.
Not even the messages within this range.
Is there a solution for this problem?

[M.Maidhof]

Hi,

thanks for the info. Yes, this is a bug which will be fixed in the next release of PCAN-View 5.x, available end of October.

regards

Michael