PCAN-RP1210

[changjae han]

Hello

rp1210 registration is not working. I installed the latest driver, but nothing is confirmed in the gateway. Do you know the cause?

[M.Heidemann]

Hello,

Can you confirm the following:

Are you using the right bitrate?

Is you bus properly terminated? (120 Ohms on both bus ends)

Please let us know.

Best Regards

Marvin

[M.Heidemann]

Also:

Make sure RP1210 API is actually installed:

rp1210.png (34.45 KiB) Viewed 4612 times

Peak-DriverSetup (Includes RP12010 API Setup):

https://www.peak-system.com/quick/DrvSetup

All connected devices during installation are automatically registered,
otherwise this can be done manually via PEAK-Settings

Best Regards

Marvin

[changjae han]

Thank you for your reply.

I tried what you said and the driver was installed normally.

I have another question.
I am trying to use the danfoss plus+1 program but it does not connect.

Do I need to set something else?

thank you

[M.Heidemann]

Hello,


This can only be done using RP1210 A which is not included in the regular RP1210 API, if you need further information,
please contact us at support[at]peak-system.com

Best Regards

Marvin

[changjae han]

Thanks for the reply.

Is it that RP-1210-A can't be downloaded?

The website says it has been merged into RP-1210-C.

Thank you.

[M.Maidhof]

Hi,

there are optional RP1210A drivers available. Contact us by email for more details.

regards

Michael