Multiple Bit Rates in Plotter

[Waipahu]

Just logged in and will be brief here.
I'm not a software guru but a tech who is quite accustomed to Canalyzer, so I bought this software to find an alternative.
I'm not seeing a way in plotter (or trace for that matter) to display two different bit rate signals in the same plot. (250 and 500 kbps)
After spending quite a bit of time on this I'm thinking it is not possible, which is a bummer for me as a lot of my analysis/troubleshooting in Canalyzer allows me to do this. These different bit rate nodes affect each other in many situations.
As I said not a software person so keeping it short as this is basics.
Thanks much, I enjoy reading here.

[M.Maidhof]

Hi,

please add another connection with your different bitrate settings and apply a symbol file or dbc to it. Then you could display the signals from the different CAN bus systems in your Plotter.

regards

Michael