PEAK-System Forum

Hi,

I'm using a PCAN-MicroMod Digital 1 along with the PCAN-USB & PCAN-Mikromod SW to program it.
I want to trigger a CAN frame on a positive edge transition on Di0.

The thing is the CAN frame is sent only once after each Micromod reset when Di0 is driven LOW->HIGH, never again after that.. When I configure "both edge", the frame is then sent twice (I don't want this) but more importantly it is still operational every time Di0 is driven LOW to HIGH to LOW.

So I'm wondering the difference of Micromod processing between the 2 configurations??

Thx for any input,

Olivier

Hello Olivier,

it´s a firmware problem, please send an email to "info@peak-system.com" and we send you a new firmware + necessary update instructions.

regards
Gunther

Hello Gunther,

Thanks for the reply, I'm relieved! I was beginning to have some serious doubts in my system.