Recievetest doesn't return any data
Posted: Mon 29. Jun 2015, 17:02
Hi,
i have installed drivers for PCAN-USB. When i run cat /proc/pcan . I get the following:
When i run ./receivetest -f=/dev/pcan32 i get:
at this point i'm stuck and don't get any data. but if i close it (ctrl+c) i get:
I am new at this so I would really appriciate any advice on how to continous data.
i have installed drivers for PCAN-USB. When i run cat /proc/pcan . I get the following:
Code: Select all
*------------- PEAK-System CAN interfaces (www.peak-system.com) -------------
*------------- Release_20141219_n (7.14.0) Jun 29 2015 16:30:06 --------------
*---------------- [mod] [isa] [pci] [dng] [par] [usb] [pcc] -----------------
*--------------------- 1 interfaces @ major 249 found -----------------------
*n -type- -ndev- --base-- irq --btr- --read-- --write- --irqs-- -errors- status
32 usb -NA- ffffffff 255 0x001c 00000000 00000000 00000186 00000000 0x0004
Code: Select all
receivetest Version "Release_20090203_n" (www.peak-system.com)
------- Copyright (C) 2004-2009 PEAK System-Technik GmbH ------
receivetest comes with ABSOLUTELY NO WARRANTY. This is free
software and you are welcome to redistribute it under certain
conditions. For details see attached COPYING file.
receivetest: device node="/dev/pcan32"
Only standard frames are accepted, init with 500 kbit/sec.
receivetest: driver version = Release_20141219_n
Code: Select all
receivetest: type = usb
Serial Number = 0xffffffff
Device Number = 255
count of reads = 0
count of writes = 0
count of errors = 0
count of irqs = 442
last CAN status = 0x0024
last error = 0
open paths = 1
driver version = Release_20141219_n
receivetest: finished (0).