Serial Bus Simulator Verification
Posted: Thu 29. Oct 2015, 18:58
Hi,
I'm new to CAN bus tinkering and I'd like to know more about what the SBS is actually doing. I have this unit along with the PEAK Diag 2 unit. The Diag 2 is supposed to allow me to sniff incoming CAN messages, and the SBS is supposed to generate messages. CAN protocol says that it should support plugging directly between two communication devices.
My question is: Can I plug the SBS into the Diag 2 in order to look at the messages coming out of the SBS?
I tried this and got nothing. I'm pretty sure that I'm doing something wrong on one of the systems. Is this even a valid exercise?
Thanks!
I'm new to CAN bus tinkering and I'd like to know more about what the SBS is actually doing. I have this unit along with the PEAK Diag 2 unit. The Diag 2 is supposed to allow me to sniff incoming CAN messages, and the SBS is supposed to generate messages. CAN protocol says that it should support plugging directly between two communication devices.
My question is: Can I plug the SBS into the Diag 2 in order to look at the messages coming out of the SBS?
I tried this and got nothing. I'm pretty sure that I'm doing something wrong on one of the systems. Is this even a valid exercise?
Thanks!