PEAK-System Forum

I have some custom software written using the PCAN-Basic DLL to interface through the PCAN-USB device. I need to add some GPIO, so I would like to move to the PCAN-MicroMod Digital. Does the PCAN-Basic API work with the MicroMods? I dont see any DLLs in the MicroMod download package.

Thanks for your help.

Hi,

the PCAN-MicroMod is not a PC CAN hardware, so you can´t use it directly through a dll. But you can configure it to a specific CAN ID, and send this CAN ID through PCANBasic/PCAN-USB to set the outputs of the MicroMod via the CAN bus.

regards

Michael