PEAK-System Forum

Hello,

In my system, I need to monitor the bus states. I saw a similar post in the forum but it looks like I can't implement the solution because it is not using PPCAN-Editor.

Is there a way to monitor the states with a specific configuration in PPCAN-Editor ?

Best regards,
Avi SZYCHTER

How do you want to monitor the BUS states? Writing on the CF card?

First of all, i would like to change the state of a LED according to the bus state, but in the end I would like to change the behaviour of the router : for instance, I want to redirect my frames from CAN-1 to CAN-4 if everything is right, but I want to redirect my frames from CAN-1 to CAN-4 if CAN-4 is unavailable.

Hi there.

No, PCAN-Router Pro does not have indicators for that.

Regards