Page 1 of 1
PCAN Mini display
Posted: Mon 22. Jan 2018, 14:45
by Haller
Is it possible to send messages with the buttons on the display?
Regards,
J.Dirks
Re: PCAN Mini display
Posted: Mon 22. Jan 2018, 17:05
by G.Bohlen
Hello,
the buttons can only be used to exit the scene or cycle trough a list of scenes.
It is only possible to send a list of predefined messages when you enter or exit a scene, or send a predefined list of messaged cyclic while the scene is active (e.g. request data from a sensor)
Regards,
Gunnar Bohlen
Re: PCAN Mini display
Posted: Mon 3. Feb 2020, 16:59
by olivierk
Hello, how can one send a predefined list of messaged cyclic with the buttons?
Thank you.
Re: PCAN Mini display
Posted: Tue 4. Feb 2020, 10:55
by G.Bohlen
Hello,
sending messages via button is not supported by the firmware.
-You can send a list of messages ONCE when a scene ist started. (e.g. initialise transmisson of sensor values from other can modules)
-You can send a list of messages CYCLIC while the scene is active (.g. request data from other modules)
-You can send a liste of messgaes ONCE when the scene is terminated. ( e.g. disable transmission of sensor values from other CAN modules)
Regards, Gunnar Bohlen