configure and serialize micromod FD modules
Posted: Fri 7. Oct 2022, 17:24
What is the recommended way to put the same configuration on multiple micromod FD Digital 2 modules?
I am currently using the PCAN-Micromod FD Configuration software then sending the project to the module over CAN.
I'd like some method that production personnel could configure it without opening the project and without potentially modifying something.
Also, is there a way to put a serial number into the configuration file? Such that production personnel could enter a serial number and it is saved in the module?
I would then be able to report the serial number over the CAN bus.
I am currently using the PCAN-Micromod FD Configuration software then sending the project to the module over CAN.
I'd like some method that production personnel could configure it without opening the project and without potentially modifying something.
Also, is there a way to put a serial number into the configuration file? Such that production personnel could enter a serial number and it is saved in the module?
I would then be able to report the serial number over the CAN bus.