PEAK-System Forum

I am currently working on a project where I simulate a converter and aim to integrate it with PLIN-View Pro for virtual LIN Communication.
Is there any way to directly integrate Simulink or MATLAB with PLIN-View Pro using PEAK APIs or another supported method, so that Simulink can act as a real-time data source or even a LIN node?
Alternatively, is it possible to stream data from MATLAB into the PLIN framework (e.g., through DLLs, COM interface, or socket communication) so the LIN master (PLIN-View Pro) can interact live with the converter simulation?
Any guidance, examples, or best practices would be greatly appreciated.

Thank you!
Best regards,
Gagan K

Hi,

AFAIK Matlab/Simulink only supports our CAN interfaces at the moment: https://de.mathworks.com/hardware-suppo ... ystem.html

So please contact Mathworks for your request, to check if they also support the PLIN interfaces in the future.

regards

Michael