PEAK-System Forum

Hello,
Two questions:
i am testing Digital inputs Do and D1 on PCAN-GPRS Link.
it seems that DInO and Din1 are inverted compared to the User Manual DIn0 is on Pin 6 and Din1 is on pin 7.
can you confirm?

in the User manual p37
Inputs 2 Low- or High-active (depending on the pull-up/-
down wiring)

why depending on the pull-up/ pull down? do we have to put a pull resistance?
From what i can measure, It seems that a pull up resistance is already mounted in the box?

Regards

Hello,

yes the names seems to be switched in the software library.

There is a pull up soldered on the board but there is also the possibility to remove it and place a pull down resistor instead.

Best Regards,
Stephan Michaelsen

Thanks.
I note

Best regards

closed