PEAK-System Forum

Using the PCAN Micromode PEAK MicroMod CANopenIA V1.01 Rev.208
Using CANopen Magic Ultimate.

Using the simple steps in the manual, I can not get it to work.

Writing NI55 to Object Dictionary entry [1F50h,03h], then reset does not change Node ID.

Saving the current configuration into non-volatile memory by writing “save” to OD entry Store Parameters [1010h,01h], or loading the default configuration by writing “load” to the OD entry Restore Parameters [1011h,01h] does not appear to work.

I am a beginner...

have you try this: LINK