Thanks!
The manual gave the impression the NODE ID change was available "after the next reset" without any other steps. Got it to work. Thanks!
BTW - The tool CANopen Magic Ultimate does have a configuration write function simplifying the 1f50.03 write method. It is under Network Overview.
Thanks!
Search found 2 matches
- Thu 23. May 2013, 00:08
- Forum: PCAN-MicroMod
- Topic: Setting Defaults after Firmware changed to CANOpen
- Replies: 1
- Views: 9158
- Tue 21. May 2013, 21:42
- Forum: PCAN-MicroMod
- Topic: Cannot Change Node ID
- Replies: 1
- Views: 6759
Cannot Change Node ID
Using the PCAN Micromode PEAK MicroMod CANopenIA V1.01 Rev.208
Using CANopen Magic Ultimate.
Using the simple steps in the manual, I can not get it to work.
Writing NI55 to Object Dictionary entry [1F50h,03h], then reset does not change Node ID.
Saving the current configuration into non-volatile ...
Using CANopen Magic Ultimate.
Using the simple steps in the manual, I can not get it to work.
Writing NI55 to Object Dictionary entry [1F50h,03h], then reset does not change Node ID.
Saving the current configuration into non-volatile ...