PEAK-System Forum

That's what I thought. Thank you for your quick answer.

Best regards.

Mandy.

Hello everyone, hello peak's community,

I need your precious help today. Indeed I got a device where I need to control the availability of the output of my PCAN-Micromod Analog 1.
This is a device where I can't put all my outputs enabled at the same time. I know how to control them by using PCAN ...

Ok I will check again.
Thank you

Edit: I checked my CAN H and my CAN L, I didn't mixed them up... Everything is good with my CAN cables

I will start over again from the beginning and I will come back to you if my problem has not been solved...
Thank you again for your help and your time.

Edit ...

Hi, sorry for the late reply and thank you for your help.

Yes I check my CAN cables and everything is fine. (with 120ohms resistors)
Indeed I get a busheavy error.

With PCAN View:
•Without connecting the module micromod analog, but connecting the PCAN-USB
==> I send a message, the message has been ...

I am using a PCAN-USB between my computer and my Micromod analog 1.

I am trying to configure the micromod Analog 1 with the software but when I want to send the configuration ==> No Modules Detected.

In tab configuration > Option > hardware I can see two PCAN-USB hardware. I don't know why I have ...

hello,

Thank you for your reply.

Yes I am using the MicroMod Configuration V2.x.
I don't think this is an hardware problem because I check every pins of the micromod analog 1 and everything is working.

About the output. Where can I modify this value? In the PWM services?

Thank you again for ...

Hello,

I am currently using a PCAN-Micromod Analag 1. I just want to use this device for reading CAN messages. The problem is the software PCAN Micromod Configuration doesn't detect my module.

Furthermore I have one more question about the voltage of the analag output. Is it possible to set the ...