PEAK-System Forum

Michael,

Are you saying you did not receive the SysInfo results file?

Thanks,
Eldon

Michael,

I sent an email to support with the files that you requested. Has there been any progress? I may have a chance to try this on another PC during the next couple of days.

Thanks,
Eldon

Michael,

The CAN bus setup works just fine because I can use the PCAN View software to monitor and write to the bus. I was able to watch the module and verify that the inputs to the module were changing. I was also able to change the status of an output on the module. When I plugged in the Analog ...

Michael,

The PCAN-USB driver is V4.1.2.16115. The OS is windows 7 x64. Also, the PCAN-USB is plugged in to a USB2 port and not a USB3 port.

Later,
Eldon

Michael,

The version on MicroMod Config is 2.5.7.63. I have not changed any settings. One other thing to note is under the Options-Hardware Tab, the PCAN USB device shows up twice but only the first one works.

The "Read Configuration" sends out the 0x7E7 command but the module never replies. If I ...

Micheal,

Thanks for the response but I only have one module on the bus at a time. As stated, the problem is when the configuration software polls the bus, the module does not respond. If I send the polling command via PCAN View, the module will respond.

Later,
Eldon

I have a MicroMod Digital 2 and an Analog 2 module. When I hook up the CAN bus from the PCAN USB adapter to a module, I can see the module transmitting data. I tell the Configuration software to find the modules on the bus and it fails. I can see the message going out on the bus @ 0x7E7. If I ...