Do you use a second CAN node, in active mode in your environment,
-Yes.
and is the PCAN-USB the 3rd or higher node?
-Yes. There are about 30 nodes.
Also, is the PCAN-USB definitaly NOT initialized (RED LED is permanent on - not flashing)
- The PCAN-USB is definitaly NOT initialized, RED LED is ...
Search found 3 matches
- Mon 28. Nov 2022, 09:45
- Forum: PCAN-USB
- Topic: change default CAN-Setup
- Replies: 5
- Views: 4745
- Fri 25. Nov 2022, 15:22
- Forum: PCAN-USB
- Topic: change default CAN-Setup
- Replies: 5
- Views: 4745
Re: change default CAN-Setup
Hi,
we were able to record that the PCAN-USB interface is transmitting into a running frame.
Our measurement setup is a CAN-Analyzer with wich we trigger a scope. Among other things the scope is connected to the rx- and tx-lines of the transceiver of the PCAN-USB.
The pulse length generated from ...
we were able to record that the PCAN-USB interface is transmitting into a running frame.
Our measurement setup is a CAN-Analyzer with wich we trigger a scope. Among other things the scope is connected to the rx- and tx-lines of the transceiver of the PCAN-USB.
The pulse length generated from ...
- Fri 25. Nov 2022, 09:48
- Forum: PCAN-USB
- Topic: change default CAN-Setup
- Replies: 5
- Views: 4745
change default CAN-Setup
Hi,
when we are using PCAN-USB interface connecterd to the CAN BUS and connected to the USB unconfigured (without using PCAN View, just physically installed) we are getting CAN passive- and active error frames.
We suppose that the default configuration of the interface does not work with our setup ...
when we are using PCAN-USB interface connecterd to the CAN BUS and connected to the USB unconfigured (without using PCAN View, just physically installed) we are getting CAN passive- and active error frames.
We suppose that the default configuration of the interface does not work with our setup ...