PCAN-LIN and PCAN-View

RS-232 to CAN/LIN Interface
Post Reply
efariv
Posts: 3
Joined: Tue 24. Sep 2019, 00:41

PCAN-LIN and PCAN-View

Post by efariv » Fri 9. Apr 2021, 01:34

Hello,

I have a PCAN-LIN configured as a LIN listener for a master and single slave system. Master Tx is message 0x6, and Rx is message 0x5. I'm able to view all LIN signals via RS232 in the "Messages and Scheduler" tab in PCAN-LIN CT. However I have a PCAN-USB w/ PCAN-View attached to the CAN pins coming out of the PCAN-LIN adapter, and I'm not seeing anything there. I've been following the "Howto_PCAN-LIN_v1.0.0.2" document to configure. I've also attached my pclin file. Could I get some advice?

Thanks,
Eric

P.S. ultimately I'm trying to setup this PCAN-LIN adapter as a LIN Master. To read and write LIN commands to the LIN slave via CAN.
Attachments
LIN_Listener.pclin
(43.78 KiB) Downloaded 3423 times

M.Maidhof
Support
Support
Posts: 1751
Joined: Wed 22. Sep 2010, 14:00

Re: PCAN-LIN and PCAN-View

Post by M.Maidhof » Fri 9. Apr 2021, 09:10

Hi,

your config looks ok, and I am able to see the CAN messages in PCAN-View. Please check that you use a terminated CAN cable between PCAN-LIN and PCAN-USB (120 Ohms on both ends), and that you have set the baudrate in PCAN-View to 500k.

regards

Michael

Post Reply