Hello,
I'm looking for an easy way to signalize that the CF card will be soon full and full using the LED(s) and/or the built in beeper. I would like to achieve this using the PPCAN-Editor 2.
Is there a way to change colors or blink frequency of the CF-LED or µC-Status (e.g. green = empty, orange = 50% filled, red = full) using a function block to compare it with "Trace File Msg Free"?
How can I control the beeper (frequency, time) to signalize the CF status (e.g. one short single beep 75% full and a fast beeping when 95% full)?
Thank you!
Signalize CF card almost full & full using PPCAN-Editor 2
-
Dominik M.
- Posts: 14
- Joined: Mon 27. Jan 2020, 09:58
Re: Signalize CF card almost full & full using PPCAN-Editor
Hello.
You obviously you have discovered all available resources indicating CF card status.
That downward counter "Trace File Msg Free" was intended to be sent over CAN to a visualisation terminal.
On the PCAN-Router Pro itself, there's no much signalling means.
Status LED and Trace LED can be controlled in C-SW only,
but then you lose the whole CF card functionality !
8 CAN LEDS are either on or off, no other settings.
Beeper is either on or off, no other settings.
Other LEDs are not populated (always dark).
You obviously you have discovered all available resources indicating CF card status.
That downward counter "Trace File Msg Free" was intended to be sent over CAN to a visualisation terminal.
On the PCAN-Router Pro itself, there's no much signalling means.
Status LED and Trace LED can be controlled in C-SW only,
but then you lose the whole CF card functionality !
8 CAN LEDS are either on or off, no other settings.
Beeper is either on or off, no other settings.
Other LEDs are not populated (always dark).