Hi,
I have downloaded the PEAK-DevPack and i ran the SetPath_for_VSCode. I am able to run the tasks like Makeall, MakeClean etc., but I am unable to start the debugging. Do i need any additional hardware to debug the code?
How to debug the code with Visual Studio Code
How to debug the code with Visual Studio Code
- Attachments
-
- Debgging error.JPG (36.92 KiB) Viewed 4119 times
-
PEAK-Support
- Sales & Support
- Posts: 1646
- Joined: Fri 10. Sep 2010, 19:34
Re: How to debug the code with Visual Studio Code
As your Firmware run on the module - you need a JTAG Debug Interface - Otherwise, how should the Debugger communicate with the Hardware 
We do not offer for the older PCAN-Router offiziell support for Debugging.
For the PCAN-Router FD and other new devices, there is also a official supported Debug Interface available, running with a STM-V2.
(see Debug Folder in the latest ARM Developer Package incl. Documentation)
We do not offer for the older PCAN-Router offiziell support for Debugging.
For the PCAN-Router FD and other new devices, there is also a official supported Debug Interface available, running with a STM-V2.
(see Debug Folder in the latest ARM Developer Package incl. Documentation)
--------------------------------
PEAK-System Technik
Technical Support Team
support[at]peak-system.com
-------------------------------
PEAK-System Technik
Technical Support Team
support[at]peak-system.com
-------------------------------