USB device error -110

[ocgltd]

When I plug my PCAN-USB FD into my linux host, the kernel log shows an error communicating with the device as shown below. Can someone advise on how to fix this?

dmesg
[ 10.984059] CAN device driver interface
[ 11.149654] peak_usb 1-1:1.0: PEAK-System PCAN-USB FD v1 fw v3.4.3 (1 channels)
[ 12.165254] peak_usb 1-1:1.0 can0: sending command failure: -110
[ 13.189348] peak_usb 1-1:1.0 can0: sending command failure: -110
[ 13.192269] peak_usb: probe of 1-1:1.0 failed with error -110
[ 13.192315] usbcore: registered new interface driver peak_usb

[root@fedora ~]# lsusb
Bus 001 Device 003: ID 0c72:0012 PEAK System PCAN-USB FD
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 002 Device 003: ID 0e0f:0002 VMware, Inc. Virtual USB Hub
Bus 002 Device 002: ID 0e0f:0003 VMware, Inc. Virtual Mouse
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub

[root@fedora ~]# ip link
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: ens192: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UP mode DEFAULT group default qlen 1000
link/ether 00:0c:29:a2:02:e9 brd ff:ff:ff:ff:ff:ff
altname enp11s0
4: virbr0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc noqueue state DOWN mode DEFAULT group default qlen 1000
link/ether 52:54:00:d5:66:57 brd ff:ff:ff:ff:ff:ff

[PEAK-Support]

We need more information
- used Linux Driver type (mainline Netdev, PEAK Netdev, PEAK chardev)
- Used Versions of driver
- We do not support any VMs questions - only real Hardware

[PEAK-Support]

user do not answer ...so topic locked...
if you solve your problem, why not share ?!?