CoDeSys&Wireless Gateway

[remote]

Hello,

I wanna use the Software CoDeSys with the Wireless Gateway to get ride of the PEAK USB Dongel. I can trace the CAN traffic with PCAN Explorer 5 using the Wireless Gateway.
But if i try to send Software updates out of CoDeSys, i get a communication Error. I think i use the wrong communication Parameter.

The attached images shows the communication box in CodeSys. If i use the USB Dongel, the driver is set to PEAK_USB. I tried PEAK_LAN, PEAK_VIRTUAL but it dosent work, i still get a communication error.

Right now i use TCP as transmission protocol on the Gateway.


Anyone got experience using CoDeSys together with the Peak Gateways?

[PEAK-Support]

Please contact 3S-Software . If they include as optional Device Type the Virtual CAN Interface it should work. It is exact the same API as used for PCAN-USB, PCAN-PCIe etc. Only the Device Handle is new (new Device Driver)
But this must be done inside CodeSys. We have no access to change / add any Device.

[remote]

Short Update, i called the Support again, they are working on it.

[PEAK-Support]

Thanks for the feedback - we know - we have send them some Ethernet and Wireless Gateways to test their development with real Hardware.

[remote]

I've just talked to the CoDeSys Support.

Bad News, they wont implement the Wireless Gateway into CoDeSys Version 2.3, it should/can work with Version 3, no real answer there.
Version 3 of CoDeSys dosent work with our Controllers. (Hydac TTC60)

Now we are at the Point were we could switch to IXXAT Hardware + IXXAT CAN Explorer, fully supported by CoDeSys or try to find a solution.

Is there any way to send the the CoDeSys Project/Boot Project form the PC to the Wireless Gateway -> Controller?

CoDeSys told me, they not responsible after the Boot Project is build.

[PEAK-Support]

Is there any way to send the the CoDeSys Project/Boot Project form the PC to the Wireless Gateway -> Controller?

Sorry, we could not help you in this matter. Good luck with the new Interface - hopefully you get the support you need..

[johannes]

Hello!

Same Problem here, just for the PCAN-Ethernet Gateway DR (IPEH 004010).
I am connected and recieve live-data from an IFM at my pc via Ethernet, visualized at the PCAN-View.
But i am not able to connect to the IFM via CodeSys. I use CodeSys 2.3 and a IFM CR0401.

There is integration for the wireless gateway, but what about the wired gateway?
Is there a solution by now? Some special CAN card driver for connecting via Ethernet?

cheerz

[PEAK-Support]

Please contact 3S - as far as we know they support the Gateways in 3-x up. See here
It makes no different if you use a Wireless CAN-Gateway (WLAN) or the Ethernet-CAN Gateway (LAN) It both ends up in a Ethernet Socket on the PC / Driver.

[bm1986]

I have a problem that i can not find the Controller in Codsys 3.5 SP14 when i use Peak wireless Gateway. instead of the normal Peak dongle the Peak Wireless Gateway is used to connect the Controller to Codesys. but i can not find the controller in Device search in codesys

[PEAK-Support]

Please contact Codesys - as far as we know you need to use the latest Version (but as i wrote - please contact the software manufacturer )