Page 1 of 1
Selected CAN-ID in Receive/Transmit window is not "sticky"
Posted: Wed 21. Sep 2016, 21:30
by Username
When observing a particular CAN-ID in the receive transmit window, if a particular message is selected, it does not remain selected when additional messages are received, because the message list gets re-sorted upon each newly appearing message. This is very frustrating when attempting to observe a particular message in real-time. Is there an option to keep the selected CAN-ID highlighted and in focus, regardless of any other messages that are subsequently appearing on the bus?
Re: Selected CAN-ID in Receive/Transmit window is not "stick
Posted: Thu 22. Sep 2016, 10:10
by M.Maidhof
Hi,
which software tool do you use, name and version will be helpfull.
regards
Michael
Re: Selected CAN-ID in Receive/Transmit window is not "stick
Posted: Fri 23. Sep 2016, 17:32
by Username
Sorry, forgot that bit:
P-CAN Explorer 5
5.4.1.898
Re: Selected CAN-ID in Receive/Transmit window is not "stick
Posted: Mon 26. Sep 2016, 08:53
by G.Lang
Hello,
you can use the filter mechanism to filter the desired message and display it only.
- display1.JPG (130.12 KiB) Viewed 5345 times
or use a symbol file and add the variable to the watch window.
- watchwindow.JPG (45.48 KiB) Viewed 5345 times
you can also use a symbol file + filter mechanism or you can add different filters or if you are working with many symbols use "marked symbols"
- markedsymbols.JPG (157.6 KiB) Viewed 5345 times
best regards
Gunther