PEAK-System Forum

Support, Knowledge Base, and FAQ
https://forum.peak-system.com/

Power routed to Pin 2 of M12 CAN connectors

https://forum.peak-system.com/viewtopic.php?t=2441

Page 1 of 1

Power routed to Pin 2 of M12 CAN connectors

Posted: Wed 6. Dec 2017, 17:49
by dfcossio
Hi,
I was wondering if it is possible to route the voltage of the external power supply to the pin 2 of the CAN M12 connectors on the PCAN-USB X6 so I can provide power to my CAN sensors using the same cable.

I've attached the pin out of my CAN sensor
CAN sensor pin out.JPG
CAN sensor pin out.JPG (18.54 KiB) Viewed 5234 times
Thanks in advance!

Diego

Re: Power routed to Pin 2 of M12 CAN connectors

Posted: Thu 7. Dec 2017, 09:19
by PEAK-Support
Sorry, this is NOT possible ! The GND (U- Pin 3) could not be used, because this is the isolated GND of the CAN Transceiver and it is NOT connected to the Supply GND !
All times are UTC+02:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited