PEAK-System Forum

Hi,

it looks like I need to provide input voltage higher then 4,7-4,8V otherwise detection is not reliable. Not I provide bit more and it works perfectly fine. Thanks.

BR,

marek

Hi,

I'm using MicroMod Mix3 to capture state of digital inputs. I use DIN0 - DIN2 as inputs and while set on all of then reference 4.8V when capture received data by using candump I see n that I get logical 1 but after some seconds it goes to logical 0 and then back to logical 1. as said I have ...

Hello,

I need same configuration to read PWM input (read freq and duty cycle) but I need 4 channels. In previous post there is mention for 2 only, so it's limited to 2 or can use more? Thanks.

Hi,

it is possible using micromod3 to read pwm frequency and duty cycle? Can this be handled by PWM inputs? Thanks.

Hi,

as said in first post I checked all manuals but cannot find any info about registers and others. So would be possible to point me to exact documentation online. Thanks a lot.

BR,

marek

Hi,

I think original one. I want to communicate with it easiest way. Thanks.

Marek

Hi,

I want to connect MicroMod3 to can bus with BBB and CAn cape. I cannot read in any manual some description of CAN setup (speed, address) and registers for controlling IO's. It's possible only in windows configuration utility to get such info? Basically I wan to to just use cansend candump to ...

Hello,

I would like to ask if I can use for PCAN-Mix3 other usb->can dongle or need to have PCAN-USB (or other) to be able to configure PCAN-Mix3. Thanks.