some question about PassThru and CANFD
Re: some question about PassThru and CANFD
Hi, hello, thank you very much for your reply. Can the passthru interface be able to set prescaler, tseg1and2, sync jump width, or is there a way to directly set the bit rate and sample point by passthru interface?
Re: some question about PassThru and CANFD
Hello,
you can set the arbitration bitrate as a pair of BTR0/BTR1 values (WORD value) over the "BaudRate" parameter of the function PassThruConnect:
PassThruConnect(DeviceID, ProtocolID, Flags, BTR0BTR1, pChannelID).
you can set the arbitration bitrate as a pair of BTR0/BTR1 values (WORD value) over the "BaudRate" parameter of the function PassThruConnect:
PassThruConnect(DeviceID, ProtocolID, Flags, BTR0BTR1, pChannelID).
Best regards,
Keneth
Keneth
Re: some question about PassThru and CANFD
Dear Mr. Wagner
I am also interested in using a CAN-FD enabled PassThru device (Peak PCI FD in my case).
How can I obtain the PT dll for this purpose?
Thanks for you assistance.
Best regards
I am also interested in using a CAN-FD enabled PassThru device (Peak PCI FD in my case).
How can I obtain the PT dll for this purpose?
Thanks for you assistance.
Best regards
- PEAK-Support
- Sales & Support
- Posts: 1646
- Joined: Fri 10. Sep 2010, 19:34
Re: some question about PassThru and CANFD
please read this https://www.peak-system.com/forum/viewt ... 2881#p8546
--------------------------------
PEAK-System Technik
Technical Support Team
support[at]peak-system.com
-------------------------------
PEAK-System Technik
Technical Support Team
support[at]peak-system.com
-------------------------------