Typically, when viewing a recorded trace with an active symbol file, hovering over the "data" column of the trace window shows the signal values. For some reason, J1939 traces don't always work this way for me.
In the first attached screenshot, I have a J1939 connection configured, with a trace open. Notice none of the ID's from the Default J1939 database are applied.
- J1939_1.png (89.27 KiB) Viewed 8857 times
If I attempt to activate the connection (no hardware is connected), I get the error shown in the second screenshot.
- J1939_2.png (141 KiB) Viewed 8857 times
Notice, however, that the ID's are now shown per the J1939 database. I would expect at this point that I could hover my mouse over the "Data" column, and view the signal values for each message, but it doesn't work that way.
I've seen this before, and with enough tinkering, I seem to be able to get it to work, but I don't think I am missing a setting. Or am I?
