6-Channel CAN FD Interface for High-Speed USB 2.0
-
dfcossio
- Posts: 1
- Joined: Wed 6. Dec 2017, 17:32
Post
by dfcossio » Wed 6. Dec 2017, 17:49
Hi,
I was wondering if it is possible to route the voltage of the external power supply to the pin 2 of the CAN M12 connectors on the PCAN-USB X6 so I can provide power to my CAN sensors using the same cable.
I've attached the pin out of my CAN sensor
- CAN sensor pin out.JPG (18.54 KiB) Viewed 5230 times
Thanks in advance!
Diego
-
PEAK-Support
- Sales & Support
- Posts: 1646
- Joined: Fri 10. Sep 2010, 19:34
Post
by PEAK-Support » Thu 7. Dec 2017, 09:19
Sorry, this is NOT possible ! The GND (U- Pin 3) could not be used, because this is the isolated GND of the CAN Transceiver and it is NOT connected to the Supply GND !
--------------------------------
PEAK-System Technik
Technical Support Team
support[at]peak-system.com
-------------------------------
