No UDP Traffic

[Archigos]

I've got a benchtop test setup with two PCAN Ethernet Gateways connected via a ethernet hub to pass CAN data in a unidirectional setup. The units show green lights indicating a good connection but I don't see any UDP traffic on the network and thus no output CAN data. The CAN Bus traffic that I want to forward uses extended message ID's but even when I just sent a single cyclic message with a 11bit ID I was still not seeing any forwarded traffic. Hoping someone can clue me in on why I don't appear to be seeing any data being forwarded?

Sending Unit Status

Sending Status

3778_Status.PNG (99.5 KiB) Viewed 4969 times

Receiving Unit Status

Receiving Status

3612_Status.PNG (98.45 KiB) Viewed 4969 times

[G.Lang]

Hello Archigos,

please update to firmware 2.6 and disable the "Listen-Only" mode at the sending unit.

best regards
Gunther

[Archigos]

Worked like a charm.